Nyrius ARIES Home Uživatelský manuál

ARIES™ HOME+ (NAVS502)INSTRUCTION MANUALWIRELESS HD TRANSMITTER

10WALL MOUNTING:(1) Drill pilot holes.(2) Insert the supplied two Anchors into the wall.(3) Insert two screws into the anchors. Leave 1/8” length fo

11TROUBLESHOOTING: No Video - Check the status of the Link LEDs, and check if the HD device is working nor-mally. - Check the HDMI lead is undamaged

12FAQank you for your purchase of the Nyrius Aries Home/Home +. If you require any assistance please review the below Frequently Asked Questions. 1

13TX/RX WILL NOW BE PAIRED : 1. RX (Receiver) : Remove mini USB power adapter, make sure RX is without power. 2. Press Power button and then plug-

14SUPPORTED RESOLUTIONS:2D VIDEO FORMAT RESOLUTION SUPPORT640x480p @ 59.94 / 60Hz 480p YES720x480p @ 59.94Hz 480p YES720x480p @ 60Hz 576p YES720x57

15AUDIO BIT RATE:Digital Audio from HDMI inputs: Up to 6Mbit/s bit-rate support. Support AC3 and DTS. 2-channel PCM: 16~24 bits audio sample with 32

16FCC STATEMENTThis device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: 1. This device may not caus

17SAFETY INFORMATIONRead all instructions.Keep these instructions.Heed all warnings.Follow all instructions.Do not use this apparatus near water.Cle

18WARRANTYThank you for choosing NYRIUS® Consumer Electronics Products!NYRIUS gives the following express warranty to the original consumer purchase

What's Included ...3Overview ..

OVERVIEW 3WHAT'S INCLUDEDRemote ControlTransmitterReceiverQuick Installation Guide Mini USB Power AdapterIR Blaster cableHDMI cableAnchors x2DC P

4RemoteA POWER BUTTONPress the power button on either the TX or RX to power on both TX and RX automaticallyB IR BUTTONPress to switch the IR Blast

5INSTALLATIONTransmitterConnect 1 or 2 high-denition audio/video sources to the transmitter Connect the transmitter’s “HDMI OUT” to the HDTV’s “HDM

6IR ExtenderPlace the two AAA batteries into the remote control.Press the Source / Input button of your TV’s remote to select the appropriate “HDMI”

7POWERDuring the warm-up, the POWER LED will blink un-til connection between the TRANSMITTER and the RE-CEIVER is established. It will take 15 - 20

8Item / Mode Status Description Power LEDMODE POWER LED SOURCE LEDSTANDBY SOLID RED OFFSEARCHING FOR CONNECTION FLASHING WHITE FLASHING WHITEItem /

9INFO KEY (REMOTE CONTROL)EXAMPLE: HDMI1(Input Displayed) CH1(Wireless Channel) 1280x1024 (Resolution) = OFF IR KEYIR blaster frequency defaul